How to make a North Eastern Barrel ( First Tutorial)

I'm making a 8 inch barrel for my commissioners snap pistol :D
First you will need 8 inches of sch 40 pvc, than 2 inches of cpvc, and last 6 inches of regular petg, scotch tape, some kind of adhesive ( I used Goop but hot glue will do just fine ), and sandpaper.

                           Second you will need to sand the lettering off the 1/2in pvc and 1/2in cpvc

                      Then you will  hammer the 2 inches of 1/2in cpvc into your sch 40 1/2in pvc

                      Third You will need to wrap your 6 inches of petg with scotch tape (Like this)

                                      

Fourth you will need to use whatever adhesive you have on the petg then push it in very quickly in the 1/2in sch 40 pvc

Last you have an 8 inch North Eastern barrel complete Enjoy 

This Specific North Eastern barrel is made for any blaster or homemade that has 3 to 4 inches of draw and that can take 1/2in sch 40 pvc

                                   This is my first tutorial so constructive criticism would be helpful